OEM 2003 Dodge Sprinter 2500 Windshield

2003 Dodge Sprinter 2500 Windshield Parts and Q&A

• Q: How to Effectively Remove and Install a Windshield on 2003 Dodge Sprinter 2500?

  A: Start by removing the windshield wiper arms and then unclamp the inner hinge, number (6). Detach the rear edge of the headliner to let the wiring harness with the connectors drop down (8). Lift off the felt strips and remove the connectors as well. After that, take out the rearview mirror from inside, remove the rain sensor and pull out the cooling system control panel console. Lift the belt line around the A-pillar, remove the door seal and unclip the A-pillar paneling above. Then, pivot the top down and pull it out of the vehicle. Shut the dashboard and louvers and then lift out the sealing frame and its mounting wedge (2). Take the windshield (1) from its frame using cutting wire and vacuum all the tiny glass pieces and any contaminants out. To install, ready the windshield and the hole by pushing the cartridge into the windshield and cutting an opening in the main mat and make sure the glue cartridge is prepared. Place a 5 cm strip of glue bead on a piece of paper and mix well, then, with the triangular nozzle at right angles, apply glue to the windshield's bottom center while following the cutout. Have the tip of the glue adjacent to the flat end so that you can smooth them together. Add the windshield to your car in just 5 minutes and don't use the car for at least 1 hour. After gluing the rain sensor, set up the inside rearview mirror and the control panel console for the vehicle cooling system. Attach the rain sensor, touch the connector together (8), cover the wiring harness with felt strips (7) and put the connectors (8) into their place in the roof recess. Apply the sun visor hinges, drop the A-pillar trim into its slot in the A-pillar and hook it at the top, insert the door seals in position under the A-pillar moldings and finish by snapping on the wiper arms and wiping the windshield.