OEM 2004 Chrysler Pacifica Automatic Transmission Filter

AT Filter
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Automatic Transmission Filter found

  • 2004 Chrysler Pacifica Automatic Transmission Filter Diagram - 4864505AB
    View related parts

    2004 Chrysler Pacifica Auto Transmission Filter Part Number: 4864505AB

    $44.78 MSRP: $66.80
    You Save: $22.02 (33%)
    Ships in 1-2 Business Days
    ADD TO CART
    Product Specifications
    • Other Name: Filter Package - Transmission Oil; Transmission Filter; Hydraulic Filter; Filter Package Transmission Oil Includes Item # 12; Filter Kit Transmission Oil
    • Item Weight: 1.00 Pounds
    • Item Dimensions: 1.6 x 7.5 x 7.5 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 4864505AB
    • Warranty: This genuine part is guaranteed by Mopar's factory warranty.
    More Info
    Fits the following 2004 Chrysler Pacifica Submodels:
    • Base, LX, Limited, Touring | 6 Cyl 3.5 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS

2004 Chrysler Pacifica Automatic Transmission Filter Parts and Q&A

  • Q: How to Service and Repair an Automatic Transmission Filter and Fluid on 2004 Chrysler Pacifica?
    A: The first step in changing the fluid and filter for the A/T is to check the vehicle's recommendations for when to change it. Always use Mopar ATF +4 and clean the magnet inside the oil pan with a cloth every time you change the fluid. If you open the transaxle, change the fluid and filter as well. First, lift the car on a hoist and put a drain container under the transaxle oil pan. Take out both nuts that bolt the engine mount-to-engine crossmember cradle, then use a jack and a wood block to gently lift the engine and transmission, so the oil pan is easier to remove. Turn out the bolts from the pan, tap a corner to break it open and lift the pan up to empty the oil. Attach a new filter and O-ring below the valve body, eliminate oil buildup using a magnet and mount the newly cleaned pan with Mopar Silicone Adhesive and 19 Nm (165 inch lbs.) of torque. Add four quarts of Mopar ATF +4 through the dipstick, start the car and let it stay running for a minute. After you've applied the parking and service brakes, briefly move the selector lever through each position and stop it in park or neutral. Check the level of transaxle fluid first, adding more fluid until it is about 3 mm below the lowest point on the dipstick and check again after the transaxle has warmed up to 180°F. Check that you have pushed the dipstick all the way in to keep grime from getting into the transaxle. Before attempting the dipstick tube fluid suction method, let the transaxle run at full operating heat, use a suitable hydraulic suction machine and make sure the line is inserted into the dipstick tube and reaches the bottom of the oil pan. After dropping the suction tube, pour four quarts of Mopar ATF +4 into the dipstick hole and start the engine. Check the level like before, making sure the dipstick is fully in place.

Related 2004 Chrysler Pacifica Parts