Other Name: Handle - Front Door Exterior; Exterior Door Handle, Front Right Outer; Outside Door Handle; Handle Front Door Exterior; Exterior Door Handle
Position: Front Outer Passenger Side
Replaces: 55362212AB
Item Weight: 1.40 Pounds
Item Dimensions: 9.2 x 8.2 x 3.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 55276882AB
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2004 Dodge Ram 2500 Submodels:
Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX4 | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 8 Cyl 5.7 L GAS
Other Name: Handle - Front Door Exterior; Exterior Door Handle, Front Right Outer; Outside Door Handle; Handle Front Door Exterior; Exterior Door Handle
Position: Front Outer Passenger Side
Item Weight: 1.30 Pounds
Item Dimensions: 10.6 x 3.3 x 2.7 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 55275948AC
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2004 Dodge Ram 2500 Submodels:
Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX4 | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 8 Cyl 5.7 L GAS
Other Name: Handle - Front Door Exterior; Exterior Door Handle, Front Left Outer; Outside Door Handle; Handle Front Door Exterior; Exterior Door Handle
Position: Front Outer Driver Side
Replaces: 55362213AB
Item Weight: 1.40 Pounds
Item Dimensions: 9.3 x 8.3 x 3.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 55275949AC
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2004 Dodge Ram 2500 Submodels:
Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX4 | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 8 Cyl 5.7 L GAS
2004 Dodge Ram 2500 Door Handle Parts and Q&A
Q: How to Service and Repair a Front Door Handle Actuator on 2004 Dodge Ram 2500?
A: Before servicing or repairing the front door interior handle, take off the door trim panel. Then, move the waterdam so it is out of the way and pull out the cable of the actuator rod from the interior door handle actuator and the door latch, if required. Remove the nuts holding the interior door handle actuator to the door and take the actuator out. Installation involves placing the actuator on the door, then adding and tightening two nuts to 10 N.m (89 in.lbs.). If you took out the actuator rod and the door latch, attach them now, then put the waterdam back into place and install the door trim panel again.