OEM 2006 Dodge Ram 3500 Power Steering Pressure Switch

2006 Dodge Ram 3500 Power Steering Pressure Switch Parts and Q&A

• Q: How to Remove and Install a Power Steering Pressure Switch on 2006 Dodge Ram 3500?

  A: The 5.7L-HD vehicles have the power steering pressure switch placed in the system's high-pressure hose. Start by taking off the connector from the power steering pressure switch. Put a container or shop towel under the switch to capture the extra fluid and use a replacement wrench on the power steering line to take off the switch without putting too much pressure. During installation, fit the switch into the power steering line, tighten it to 8 - 11 Nm (70 - 100 inch lbs.) and reconnect the electrical connector to the switch. When installation is done, check the power steering fluid, top it up if necessary and check it again a second time after starting the engine.