OEM 2007 Chrysler Aspen Throttle Cable

2007 Chrysler Aspen Throttle Cable Parts and Q&A

• Q: How to Service and Repair a Throttle Cable for the 4.7L V-8 on 2007 Chrysler Aspen?

  A: Hold up the accelerator pedal inside the car and detach the retaining clip and core wire at the top of the pedal arm (6). Following this, pull the core cable wire off the pedal arm and take out the clip (2) from the dash that holds the cable down. Lift out the throttle air box and pull the cable off its clip on the dash panel. swap the cable housing from the dashboard into the hood of the car. Push your thumb sideways to the front of the vehicle on the connector as you pry the cable away from the bellcrank pin at the throttle body (4). From the top part, lift the accelerator cable off the cable cam (6) and push tab (3) to release the plastic mount from the bracket, making certain not to push too hard since this may break the tab. After that, move the plastic mount over to the passenger side to take the throttle cable out of its bracket and out of the vehicle.