OEM 2008 Dodge Durango Hood Latch

2008 Dodge Durango Hood Latch Parts and Q&A

• Q: How to Service and Repair a Hood Latch on 2008 Dodge Durango?

  A: The first thing you should do is remove the grille, then remove the hood latch (4). After that, take off the left headlamp cover and the plastic rivets to put out the left front wheelhouse splash guard. After removing the release cable, take out the retainer clips (2) close to the engine and release the grommet attached to the dash panel hole. After that, remove the release cable and two retainer clips (4). Inside the car, remove the five screws holding the hood release handle (2) to the bottom of the instrument panel (1). Afterward, run the hood release cable via the hole in the dash panel and take it out from the inside of the car.