How to Install a Seat Heater Switch for ATC and MTC Systems on 2010 Dodge Grand Caravan?

Place the A/C-heater control (2) in the instrument panel center bezel (3) and hold it in place with screws (1). Tighten the screws to 2 Nm (17 in. lbs.). Every wire connector matches a specific receptacle on the A/C-heater control, so during reinstallation, you must note each connector's color and place to avoid risking damage from forcing a connector into the wrong slot. When the A/C-heater control is in place, set the instrument panel center bezel (1) and rejoin the negative battery cable. The last step is to calibrate the A/C-heater control.

OEM 2010 Dodge Grand Caravan Seat Heater Switch

Seat Heater Level Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Seat Heater Switch found

View related parts
2010 Dodge Grand Caravan Switch Part Number: 68024996AB
Product Specifications
- Other Name: Switch - Heated Seat; Seat Heater Switch; Switch Heated Seat
- Replaces: 68024996AA
- Item Weight: 0.40 Pounds
- Item Dimensions: 1.5 x 1.6 x 1.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68024996AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Dodge Grand Caravan Submodels:
- C/V, SE, SXT | 3.3L V6, 3.6L V6, 3.8L V6, 4.0L V6, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS

2010 Dodge Grand Caravan Seat Heater Switch Parts and Q&A

Q: How to Install a Seat Heater Switch for ATC and MTC Systems on 2010 Dodge Grand Caravan?
A: Place the A/C-heater control (2) in the instrument panel center bezel (3) and hold it in place with screws (1). Tighten the screws to 2 Nm (17 in. lbs.). Every wire connector matches a specific receptacle on the A/C-heater control, so during reinstallation, you must note each connector's color and place to avoid risking damage from forcing a connector into the wrong slot. When the A/C-heater control is in place, set the instrument panel center bezel (1) and rejoin the negative battery cable. The last step is to calibrate the A/C-heater control.