How to Install a Door Lock Cylinder for the Front Half Door on 2010 Jeep Wrangler?

Assembly gasket 1 to lock cylinder 2 until the gasket is completely seated to begin installing the front end. After that, place lock cylinder 2 into the outer door panel, so that it is pointing forward and the drain hole is pointing down. Make sure the lock cylinder is steady and slip the retainer clip over it before checking that a pin on the cylinder goes into the bell crank in the door module as you install it. You should now install latch 5.

OEM 2010 Jeep Wrangler Door Lock Cylinder

Door Lock Cylinder Tumbler

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Door Lock Cylinder found

View related parts
2010 Jeep Wrangler Lock Cylinder, Front Part Number: 68001713AA
$71.89 MSRP: $107.00
You Save: $35.11 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Cylinder - Door Lock; Door Lock Cylinder, Front; Trunk Lock Cylinder; Cylinder & Keys; Cylinder Door Lock for Doors and Tailgate.
- Position: Front
- Replaces: 4864651
- Item Weight: 0.60 Pounds
- Item Dimensions: 3.2 x 3.1 x 1.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68001713AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Jeep Wrangler Submodels:
- 65th Anniversary Edition, 70th Anniversary, 75th Anniversary, Rubicon, SE, Sahara, Sport, Sport S, Unlimited, Unlimited 70th Anniversary, Unlimited 75th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited Sport S, Unlimited X, X | 4 Cyl 2.4 L GAS, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS

2010 Jeep Wrangler Door Lock Cylinder Parts and Q&A

Q: How to Install a Door Lock Cylinder for the Front Half Door on 2010 Jeep Wrangler?
A: Assembly gasket 1 to lock cylinder 2 until the gasket is completely seated to begin installing the front end. After that, place lock cylinder 2 into the outer door panel, so that it is pointing forward and the drain hole is pointing down. Make sure the lock cylinder is steady and slip the retainer clip over it before checking that a pin on the cylinder goes into the bell crank in the door module as you install it. You should now install latch 5.