JeepParts
My Garage
My Account
Cart
OEM 2010 Jeep Wrangler Knock Sensor
Engine Knock Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Knock Sensor found
2010 Jeep Wrangler Knock Sensor Part Number: 5033316AB
$128.23 MSRP: $194.00You Save: $65.77 (34%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Sensor - Knock; Ignition Knock (Detonation) Sensor; MAP Sensor; Sensor Knock
- Replaces: 5033316AA, 56028563AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.1 x 1.3 x 2.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033316AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2010 Jeep Wrangler Knock Sensor Parts and Q&A
- Q: What is the Correct Method for Installing a Knock Sensor on 2010 Jeep Wrangler?A: Clean the area around the knock sensor mounting hole before installing it. Adjust the position of your sensor to the engine and check that the bolts are fastened with just the right amount of force. For the knock sensor bolt, always use 15 +/- 2 ft. lbs., because it can be a little tough to get the correct torque on an 8 mm bolt. The foam on the bolt threads is used to keep the bolts in place when you install the sensors; do not seal, lock or use glue on these bolts. Screw down the mounting bolt, connect the electrical wire to the sensor, drive the vehicle to the ground and then reconnect the negative terminal.
Related 2010 Jeep Wrangler Parts
2010 Jeep Wrangler Fuse Box
2010 Jeep Wrangler Camshaft Position Sensor
2010 Jeep Wrangler Oxygen Sensor
2010 Jeep Wrangler Coolant Temperature Sensor
2010 Jeep Wrangler Ignition Coil
2010 Jeep Wrangler Seat Belt
2010 Jeep Wrangler Engine Control Module
2010 Jeep Wrangler Oil Pressure Switch
2010 Jeep Wrangler Relay
2010 Jeep Wrangler MAP Sensor
2010 Jeep Wrangler Ignition Lock Assembly
2010 Jeep Wrangler Intake Manifold Temperature Sensor