OEM Chrysler LHS Power Window Switch

Chrysler LHS Power Window Switch Parts and Q&A

• Window Switch, Black, Front Passenger Side
  56007695AD
  Q: How to Replace a Power Window Switch on Chrysler LHS?

  A:

  Before changing the power window switch, you have to open the hood and disconnect the negative battery cable remote terminal from its battery post. After that, press a trim stick (special tool #C-4755) or similar tool under the bezel and lift the bezel up to remove it from the trim panel. Unplug the wire harness from the switch in the back and pull out the switch from inside your vehicle. When setting up, use the process you followed in the freeing stage, just in the reverse order.
• Window Switch, Black, Front Driver Side
  5026004AA
  Q: How to Maintain and Fix a Power Window Switch on Chrysler LHS?

  A:

  Open the hood and, using an insulated wrench, separate the negative battery cable remote terminal from the remote battery post. To remove the master switch, place the special trim tool C-4755 beneath its bezel and pry it up, then lift out the bezel and disconnect the wire from the back of the switch before pulling the switch out. Before switching, open the door trim panel, disconnect the switch's wire and remove the switch part from the vehicle and its bezel. Start by opening the rear door and pushing slightly up on the rear side of the switch while also pushing toward the switch opening. Then pull the whole switch up and out of its place. Pull each tab on the side of the switch connector, then pull the connector out of the switch. Then, carefully lift the switch from the vehicle. For installation, join the wire connector with the master switch, place the switch on the trim panel and put back the negative battery cable at the remote terminal. Attach the switch and connector for the passenger door, add the door panel, then hook up the negative battery cable remote terminal and the door trim once again. To set up the rear door switches, fit the connector to the switch, set it into the door trim panel and attach the negative battery cable remote terminal back.