OEM Chrysler Voyager Camshaft Position Sensor

Chrysler Voyager Camshaft Position Sensor Parts and Q&A

• Camshaft Position Sensor
  4686353
  Q: How to Locate and Replace a Camshaft Position Sensor on Chrysler Voyager?

  A:

  It is situated in the back of the cylinder head. Take out the negative battery cable and unplug the electrical connectors from the Camshaft position sensor afterward. After that, remove the screws on the stand that hold the sensor place and take the sensor out. Unscrew the magnet on the back of the camshaft and then take it off. To mount the target magnet, hold it at the end of the camshaft, get the locating dowels into the screw holes, put the screw on tightly (3 Nm or 30 in. lbs. of torque) and ensure you do not twist it too hard, as this may break the magnet. Place the camshaft position sensor, then tighten the screws that hold it using 115 in. lbs. (12.9 Nm) torque. Make sure the camshaft position sensor's pins are in the right place before tightening the electrical connector, avoid installing it tilted. After that, get the negative battery cable and plug it back into place.
• Camshaft Position Sensor
  5093508AA
  Q: How to Remove and Install a Camshaft Position Sensor on Chrysler Voyager?

  A:

  You will find the Camshaft position sensor at the back of the cylinder head. Remove the negative battery cable initially and then unplug the connectors from the camshaft position sensor. Following that, unscrew the mounting bolts of the camshaft position sensor and take out the sensor. Take out the screw in the back of the camshaft that holds the target magnet and take the magnet off. When installing, fit the main magnet to the end of the camshaft so it sits inside the housing, tighten the mounting screw to 3 Nm (30 in. lbs.) and make sure not to overtighten to avoid breaking the magnet; if any cracks appear, replace it. Secure the camshaft position sensor by using 12.9 Nm (115 in. lbs.) torque on the screws. Slowly attach the electrical connector to the camshaft position sensor and after that, reconnect the negative battery cable.