OEM Dodge Ram 2500 Wiper Blade

Dodge Ram 2500 Wiper Blade Parts and Q&A

• Blade Assembly
  55076910AA
  Q: Can Wiper Blades Be Swapped Between the Driver and Passenger Sides on Dodge Ram 2500?

  A:

  You can't switch these blades because the driver side includes an extra bridge and eight claws, while the passenger side only has six claws. Point the notched retainer end of each wiper toward the tip of the wiper that connects to the wiper unit near its pivot. Turn the wiper control knob upwards and use the ignition switch to move the blades over a convenient place for removal. First, use the Wiper Arm to lift the blade off the glass, then press the tiny button at the tip of the pivot block to release the Wiper Pivot from the hook. With care, remove the wiper hook on each wiper arm tip from its corresponding hole in the mounting bracket ahead of the pivot block/latching mechanism, to avoid the wiper arm springing if you let go. Carefully place the wipers part down on the window. To install, spin the wiper away from the window, bring the wiper blade close by the added hook part, turn the notched part so it points to the wiper pivot and insert the hook part through the hole in the blade until it hooks to the pivot. Pull the wiper blade pivot block/latch up into the hook and hold it there until the latch tab snaps in. Then, gently drop the wiper down on the windshield.
• Wiper Blade, Front
  55077100AE
  Q: How to Replace a Wiper Blade on Dodge Ram 2500?

  A:

  Before taking out the wiper blade, raise the Wiper Arm like in the below instructions until the arm fully sits to the right. Press the latch release tab that's underneath the tip of the arm and slide the blade toward the arm's pivot point to detach the pivot block from the hook at the arm's end. Grasp the hook at the end of the wiper arm and push it into the opening in the wiper superstructure close to the pivot block and then lower the tip of the wiper arm onto the glass. While installing, remove the wiper arm from the glass so the hinge is in its pointed up position. Attach the end of the wiper element flexor to the upward-facing side of the hook by the pivot. Bring the hook formation into position by inserting it through the blade superstructure in front of the pivot block, so the pivot blocks can be fit together. Move the pivot block all the way up into the hooks and make sure you hear the latch release tab click as it locks. After that, lower the wiper blade and element onto the windshield.