For a gasoline engine, unhook and isolate the battery's negative wire before you remove the windshield washer reservoir. After that, take out the coolant overflow hose from the nipple on the radiator filler neck, but do not open or drain the engine cooling system. After that, remove the reservoir washer hose from the barbed nipple of the inline fitting in the right headlamp and dash wire harness so that the washer fluid can drain into a container you can use again. Remove both the right headlamp and dash wire harness connector from the washer fluid level switch connector receptacle and from the washer pump/motor unit connector receptacle. Untighten the two screws in the top of the radiator shroud that hold the reservoir brackets in place. Tugs hard on the reservoir's bottom, lifting it sharply away from the depression in the radiator shroud to free the locking tab. Lift the washer reservoir higher still so that the two mounting tabs on the reservoir clear the two slots in the radiator shroud, then pull the reservoir out from its position on the right side of the engine compartment.