OEM Dodge Sprinter 2500 Water Pump

Dodge Sprinter 2500 Water Pump Parts and Q&A

• Water Pump
  5138057AA
  Q: How to Remove and Replace a Water Pump on Dodge Sprinter 2500?

  A:

  Begin by removing the front Bumper from models 901.0/3/4, 902.0/3/4, 903.0/3/4 and 904.0/3/4 and the front Grille for models 901.6, 902.6, 903.6 and 904.6 up to model year 2003 and for models 901.6, 902.6, 903.6 and 904 After that, uninstall the left headlamp for models 901.6, 902.6, 903.6 and 904.6. Take off the coolant hoses, remove the electrical connector from the circulation pump and disconnect the coolant hoses from the pump's connecting pipes while placing any coolant that escapes in a clean vessel. Then, remove the nuts, get out the previous circulation pump and reinstall the new pump back into the heater unit bracket, but from the other way round. For safety, keep the vehicle from moving, dress properly so your clothes won't come off and stay away from hot or rotating equipment. After installation, turn on the engine and let the cooling and heating system bleed, letting the engine idle at alternating speeds for just one minute. After you power off, test the coolant's level, fill it if not full, glance at the hoses on the circulation pump for leaks and sort out any problems with the auxiliary heater.
• Water Pump
  68087367AB
  Q: How to Install an Auxiliary Water Pump on Dodge Sprinter 2500?

  A:

  Attach the electric coolant pump to the bracket with the approved fasteners first. Then, twist one heater hose onto the discharge port of the electric coolant pump and the other onto its suction port. Tighten the hose clamps firmly so that water does not leak. Insert the wire harness connector into the electric coolant pump and bring the negative Battery Cable back into connection. After that, place the air cleaner housing and top up the engine cooling system to finish installing the car.