OEM Dodge Stratus Washer Reservoir

Dodge Stratus Washer Reservoir Parts and Q&A

• Washer Reservoir
  5019323AC
  Q: How to Replace the Washer Reservoir on Dodge Stratus?

  A:

  Before replacing the windshield washer reservoir, you should unplug the battery remote cable first. Then, pull off the washer fluid hose from the connector on the upper top of the right shock tower. Take out part of the bumper section if you need to to reach the reservoir. Undo the wire connector from the Washer Pump and the harness tab and after that remove the mounting bolts from the washer reservoir. Move the reservoir to the rear and let it drop out of the vehicle as you drain the washer fluid and unplug the washer hose. To set up the washer, attach the hose to the reservoir and securely install the reservoir. Install the wire connector once again to the washer pump and the harness mounting tab. If some of the interior skin had to be pulled back, fix it as you move on. Connect the hose from the washer fluid at the in-line connector on the right shock tower, add the fluid and afterwards reattach the car battery's negative remote cable.
• Washer Reservoir
  MR522403
  Q: How to Maintain and Fix a Washer Reservoir on Dodge Stratus?

  A:

  Cover or remove and isolate the battery's negative remote cable before servicing or repairing the windshield washer reservoir. After that, detach the washer fluid hose from the connector found on top of the right shock tower. Take off the lower portion of the bumper to get to the reservoir. Remove the wire connector from the pump and the tab it is attached to and take out the mounting bolts from the washer reservoir. Pull the reservoir out from the front and drop it behind the car, letting the washer fluid settle somewhere appropriate and then unhook the washer hose from the reservoir. Start by connecting the washer hose to the reservoir and putting in the washer fluid reservoir for installation. Join the wire connector with the pump and the harness mounting point once more. Should part of the fascia have been removed, install a replacement whenever possible. Fit the washer fluid hose to the pump inside the reservoir, fill the washer fluid and then plug the negative end of the battery remote cable back in.