2003 Jeep Liberty Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2003 Jeep Liberty

• Q:

  How to Replace a Faulty Clock Spring on 2003 Jeep Liberty?

  A:

  Replace the Clock Spring if it is faulty or has been airbag deployed as the clock spring cannot be repaired. Disable the restraint system, remove the airbag and steering wheel and the Clock Spring. Reinstall by centering the new Clock Spring, reconnecting harnesses and securing the shrouds and steering wheel.
• Q:

  How to Maintain the Air Bag Control Module on 2003 Jeep Liberty?

  A:

  To service the air bag Control Module you must disconnect the battery negative cable and wait two minutes. Remove the center console and ACM cover and then separate the ACM from its bracket. Disconnect the wire harness, install the new ACM, reconnect the wire harness, and reassemble the whole thing without reconnecting the battery until after testing has been completed.
• Q:

  How Does an Air Bag Sensor Ensure Safety During Servicing on 2003 Jeep Liberty?

  A:

  Before servicing vehicles with air bags, turn off the supplemental restraint system by disconnecting the negative battery cable and wait two minutes. Remove the front impact sensor carefully, without dropping it. Reinstall the sensor and reconnect the wiring and lock it before performing the air bag system verification test.
• Q:

  How to Safely Arm and Disarm an Airbag System on 2003 Jeep Liberty?

  A:

  To put the airbag system on or off, begin by disconnecting the negative battery cable. Wait at least two minutes before waiting for the capacitor to discharge as this is the safest way to disable the airbag system. Skipping this step may lead to the accidental deployment and potential injury.