2004 Chrysler Sebring Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2004 Chrysler Sebring

• Q:

  How to Service an Air Bag Control Module on 2004 Chrysler Sebring?

  A:

  In order to service the Air Bag Control Module, remove the battery negative cable and wait two minutes. Take out the shifter knob and boot (manual) or bezel (automatic), disassemble the console and parking brake lever by unscrewing it. UnInstall, Reconnect, Install Components. It is strongly advised not to reconnect the battery until testing is done.
• Q:

  What Needs Inspection and Replacement After an Airbag Deployment on 2004 Chrysler Sebring?

  A:

  All replace Driver air bag, Clock Spring Assembly, Steering Wheel & Steering Column Assembly. Inspect other parts for damage. For deployed Passenger and Curtain air bags replace respective assemblies and inspect others. Replace front seat belt retractors and buckles, vacuum the interior of the vehicle for powder residue.
• Q:

  How to service an Air Bag Sensor on 2004 Chrysler Sebring?

  A:

  To service the satellite acceleration sensor, disconnect the battery negative cable, and wait 2 minutes. Remove the lower B-pillar trim, disconnect the sensor and remove it. Install the new sensor with the connector facing forward, torque screws to 7 Nm, reconnect electrical connector and reinstall trim. Do not reconnect the battery until the airbag system has been tested.
• Q:

  How to Maintain a Clock Spring Assembly on 2004 Chrysler Sebring?

  A:

  To service the Clock Spring Assembly, disconnect the negative cable to the battery and wait for two minutes. Remove Steering Wheel, due to wires protected. Replace clock spring if defective or after airbag deployment. Center and install the new clock spring and re-install the multi-function switch and steering wheel. Do not reconnect the battery until after testing is completed.