2004 Dodge Dakota Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Airbag, Clock Spring Installation and Repair Tips for 2004 Dodge Dakota

• Q:

  How to Service an Air Bag Control Module on 2004 Dodge Dakota?

  A:

  To service the Air Bag Control Module, remove the battery negative cable and wait two minutes. Remove the floor duct adapter and get access to the ACM. Disconnect the wire harness, and then remove the ACM. For installation, reconnect the harness, install the ACM and repair the components. Do not reconnect the battery until all the verification testing is finished.
• Q:

  How to Replace a Faulty or Damaged Airbag on 2004 Dodge Dakota?

  A:

  To replace a faulty driver air bag, disconnect the battery, wait 2 minutes and remove the air bag from the steering wheel. Remove the electrical connections, then place the new air bag in the proper connections and position. Finally, tape it with the screws and do a check test before you connect the battery again.
• Q:

  Is It Necessary to Replace the Clock Spring if It's Faulty, Damaged, or After Airbag Deployment on 2004 Dodge Dakota?

  A:

  Replacement of Clock Spring is necessary whenever faulty or following airbag deployment because it cannot be fixed. Deactivate restraint system, take off airbag and steering wheel then the shrouds. Disassemble Clock Spring, replace with a new one, and reestablish all connections making sure that all is aligned.