2005 Dodge Dakota Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2005 Dodge Dakota

• Q:

  How to Safely and Correctly Service an Air Bag Control Module on 2005 Dodge Dakota?

  A:

  To service the Air Bag Control Module, disable the supplemental restraint system by disconnecting the battery negative cable and wait for two minutes. Avoid dropping Occupant restraint controller as it must be replaced if it is damaged. You must follow proper removal and installation procedures, making sure all connections are secure and then reconnecting the battery.
• Q:

  How to Service an Air Bag Sensor for Side Impact on 2005 Dodge Dakota?

  A:

  To service the side impact sensor, disconnect the battery and wait two minutes, and remove the scuff plate trim and carpet. Unscrew and disconnect the sensor, and install the new sensor making sure it is properly aligned and install. Finally, put the carpet back and trim, and do a check before reconnecting the battery.
• Q:

  How to Maintain and Fix a Clock Spring on 2005 Dodge Dakota?

  A:

  In order to fix Clock Spring Assembly, a restraint system can be turned off by pulling the battery. Take out the airbag and steering wheel, and the top and bottom shroud. Install or replace the Clock Spring aligning it appropriately. Install the shrouds again, the steering wheel and airbag, and the battery.
• Q:

  How to Safely Arm and Disarm an Airbag System on 2005 Dodge Dakota?

  A:

  To put the airbag system on or off, begin by disconnecting the negative battery cable. Wait at least two minutes before waiting for the capacitor to discharge as this is the safest way to disable the airbag system. Skipping this step may lead to the accidental deployment and potential injury.