2005 Jeep Grand Cherokee Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2005 Jeep Grand Cherokee

• Q: How Does Clock Spring Ensure Safe Installation of a Replacement Steering Control Module on 2005 Jeep Grand Cherokee?

  A: To avoid being injured, first disable the airbag system when maintaining components of the steering wheel. Un-connect the battery and wait 2 minutes. Install the Clock Spring making sure the airbag wires run in the same direction. Install the Clock Spring to the Steering Control Module (SCM) and reinstall the SCM using the front wheels straight.
• Q: How to Service the Air Bag Sensor in the C-Pillar on 2005 Jeep Grand Cherokee?

  A: To service the C-pillar side impact sensor, turn off the negative connection on the battery and wait two minutes. Remove the quarter trim panel and two of the screws to get at the sensor. Disconnect the harness and replace and secure the sensor. Reinstall the trim panel, but don't reconnect the battery until tests have been done.
• Q: How to Safely and Correctly Service the Air Bag Control Module on 2005 Jeep Grand Cherokee?

  A: To service Air Bag Control Module, disconnect the battery negative cable to wait two minutes and then disconnect it. Do not drop Occupant Restrainer Controller (ORC). Take out and fit the ORC taking care to connect and orient correctly and do a verification test before reattaching the battery.
• Q: What Steps Should Be Taken After an Airbag Deployment on 2005 Jeep Grand Cherokee?

  A: After a supplemental restraint deployment, deployed restraints must be replaced for vehicle use. This includes the Clock Spring/SCM, instrument panel top pad, seat belt tensioners, and complete air-bag unit for side curtains. Inspect sunroof drain tubes and ensure proper mounting of sensors to prevent air bag issues. Other components should be inspected and replaced as needed.