2006 Chrysler 300 Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2006 Chrysler 300

• Q:

  How to Maintain a Windshield Washer Fluid Reservoir on 2006 Chrysler 300?

  A:

  To access the windshield washer reservoir, disconnect the battery negative cable, remove the front fascia and disconnect the electrical harness. Drain the fluid, remove the reservoir and reinstall it with mounting fasteners torqued to 7 N.m. Reconnect everything and fill the reservoir then reinstall the front fascia.
• Q:

  How to Maintain the Front Wiper Arm on 2006 Chrysler 300?

  A:

  To service the front wiper arm, remove nut caps 3 and retaining nuts 4. Use a two-jaw puller to detach wiper arm 7, then remove wiper arms 1 and 2. For installation, secure wiper arms 1 with nuts 4 at 18 N.m (13 ft. lbs.) and replace nut caps 3.
• Q:

  How to Service and Repair a Front Wiper Motor on 2006 Chrysler 300?

  A:

  To service the front wiper motor, disconnect the battery negative cable and remove the wiper module. Remove the bellcrank to the motor shaft, and then remove the motor mounting bolts. Don't lose the pocket nuts for reinstalling. Install the new motor, making sure that the shaft seal is in place, and reverse assemble the module.