2007 Dodge Ram 2500 Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2007 Dodge Ram 2500

• Q:

  How to Safely Service an Air Bag Control Module on 2007 Dodge Ram 2500?

  A:

  To maintain the Air Bag Control Module, one has to turn off the supplemental restraint system by disconnection, and wait two minutes with battery negative cable. The occupant restraint controller should be handled with care to prevent damage. Install it properly and fix it with nuts, reconnect wire harness, and cover and then reconnect the battery.
• Q:

  How to Remove the Clock Spring Assembly on 2007 Dodge Ram 2500?

  A:

  The Clock Spring Assembly can be removed by disabling the airbag system by disconnecting the battery. Unfold driver airbag, steering wheel and shrouds. Unscrew wire harness and disconnect connector screws on Clock Spring. Reusing: in case of reusing, the rotor must be secured to ensure centering until it is reinstalled; otherwise, it must be centred prior to reinstalation.
• Q:

  How to Replace a Damaged or Ineffective Airbag on 2007 Dodge Ram 2500?

  A:

  In order to replace side curtain air bag, disable supplemental restraint system by removing the battery negative cable. Put on protective equipment when working with the air bag. Installation of the air bag, connecting it with screws, reconnection of the harness and tether clips. Install back the headliner and leave the battery unconnected until testing is done.
• Q:

  How to Service an Air Bag Sensor on a Mega Cab on 2007 Dodge Ram 2500?

  A:

  To service the side impact sensor of the Mega Cab turn off the supplemental restraint system by unplugging the battery negative cable. Move the front seat to gain access, loosen the securing nut and detach the sensor. The body wire harness can be disconnected and a sensor can be replaced in case it dropped to be properly functioning.