2007 Dodge Ram 2500 Crankshaft Position Sensor, Engine Control Module, Ignition Coil, Spark Plug

Crankshaft Position Sensor, Engine Control Module, Ignition Coil, Spark Plug Installation and Repair Tips for 2007 Dodge Ram 2500

• Q:

  How to access and remove the Spark Plug located beneath its ignition coil on 2007 Dodge Ram 2500?

  A:

  Removal of the coil as well as the throttle-body tubing, since each spark plug is typically underneath its ignition coil. Employing compressed air around the coil base and in the cylinder head is to prevent debris. A rubber insert socket removes the plug; the coil O ring and plug are inspected and replaced if required.
• Q:

  How to Install and Verify the Functionality of an Engine Control Module on 2007 Dodge Ram 2500?

  A:

  To install the Engine Control Module (PCM) Disconnect the ABS CAB Change the PCM Use a scan tool to write the VIN Secure the PCM, look for damage to connectors and reconnect. For 5.7L V-8 engine, to do parameter learning, turn ignition ON for 10 seconds.
• Q:

  Where is the Crankshaft Position Sensor located and How to remove it on 2007 Dodge Ram 2500?

  A:

  Typically, the Crankshaft Position (CKP) sensor is at the right-rear side of the engine block and is bolted in a machined hole. Access is obtained, which disconnects the wiring connector and removes the mounting bolt. Depending on the condition, the O-ring should be inspected after twisting free and withdrawal of the sensor.
• Q:

  How to Service and Repair an Ignition Coil for a 5.7L Engine on 2007 Dodge Ram 2500?

  A:

  To service the 5.7L engine's ignition coil, blow out dirt around the spark plug, apply dielectric grease to the boots, and position the coil onto the spark plugs. Tighten the mounting bolts to 7 Nm (62 in.lbs.) and connect the electrical connector by snapping it into place.