2007 Jeep Commander Door Hinge, Door Check, Door Latch Assembly, Exterior Door Handle

Door Hinge, Door Latch Assembly, Exterior Door Handle Installation and Repair Tips for 2007 Jeep Commander

• Q:

  How to Maintain and Fix a Door Hinge Without Taking the Door Off on 2007 Jeep Commander?

  A:

  To fix the door hinge on the back door, replace the hinges one at a time without needing to remove the door. Open the front door, disconnect the rear door wire harness and mark hinge locations. Prop the door, remove bolts and remove it. Remove hinge nuts and washers if necessary but do not separate epoxy bonded washers.
• Q:

  How to Install a Door Latch Assembly on 2007 Jeep Commander?

  A:

  Installation of the front door latch, the actuator rods can be attached, and the retainers are to be engaged. Install the latch assembly in the door, fix it with three bolts at 10.5 Nm, install the wire harness, install the interior handle actuator rod and install the exterior handle rod.
• Q:

  How to Install a Front Exterior Door Handle on 2007 Jeep Commander?

  A:

  To install the front door exterior handle first insert the lock cylinder into the handle. Position handle at the mounting hole and tighten with three bolts to 7 Nm (60 in. lbs.). Connect the actuator rods, and then install the door glass and adjust the latch, if necessary.