2007 Jeep Commander Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2007 Jeep Commander

• Q: How to Service and Repair a Rear Wiper Arm on 2007 Jeep Commander?

  A: To fix the rear wiper arm, a small screwdriver is required to lift off the plastic cap at the bending point. Take away the securing nut making sure not to use battery terminal pullers to avoid damage. Lastly, swing the arm to release it off the park ramp and rock it off the shaft of output.
• Q: How to Maintain a Windshield Washer Fluid Reservoir on 2007 Jeep Commander?

  A: To service the windshield washer reservoir, disconnect the negative battery cable, turn the steering wheel to the left and open the reservoir cap. Remove the blind rivet, raise the vehicle and remove the splash shield. Remove the wire harness, take note of hose positions, drain the fluid and remove the reservoir from the frame.
• Q: How to Remove a Front Wiper Motor on 2007 Jeep Commander?

  A: To remove the front wiper motor, disconnect the battery negative cable, remove the wiper arms and cowl cover, then unscrew the module bracket. Disconnect the wire harness from the wiper motor and finally, take out the wiper module as a complete unit.