2008 Dodge Sprinter 2500 Door Hinge, Door Check, Door Latch Assembly, Exterior Door Handle

Door Check, Door Hinge, Door Latch Assembly, Exterior Door Handle Installation and Repair Tips for 2008 Dodge Sprinter 2500

• Q:

  How to Service and Repair a Right Door Latch Assembly on 2008 Dodge Sprinter 2500?

  A:

  To repair the right rear door latch, remove the lower and upper door trims, inside door handle, and mark the upper latch's position. Remove the upper latch, release the lock cylinder, unscrew the door latch bolts, and disconnect cables and electrical connectors before removing the latch assembly.
• Q:

  How to Safely and Effectively Service a Door Hinge on 2008 Dodge Sprinter 2500?

  A:

  To service the rear door hinge safely, replace hinges one at a time without removing the door. Use a body sealant when moving hinges. Support the door, mark hinge locations, and remove the bolts from both the body and door to take out the hinge.
• Q:

  How to Install a Front Door Check on 2008 Dodge Sprinter 2500?

  A:

  To install the check on the front door, fix them with bolts at 9 Nm. Connect it to the A-pillar, fixing the bolt at 23 Nm. Install the watershield, speaker and connect the speaker electrical connector. Finally install the front door control unit and door trim panel.
• Q:

  How to Install a Sliding Exterior Door Handle on 2008 Dodge Sprinter 2500?

  A:

  To install the sliding door handle, insert the exterior handle into the door, position the seal, and place the cap. Secure with the bolt, tightening to 3 Nm (26.5 in. lbs.), then finish by placing the trim cap over the assembly.