2009 Chrysler 300 Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2009 Chrysler 300

• Q:

  How to Safely Remove an Air Bag Sensor from the Front and Side Impact Areas on 2009 Chrysler 300?

  A:

  To take off the front impact sensor, remove the battery negative cable and wait two minutes to discharge the air bag system. For the left sensor, get rid of the air intake system. For B- and C-pillar sensors disconnect the battery, wait, remove the trim panel and disconnect the electrical connectors.
• Q:

  How to Safely Service the Steering Column Control Module with a Clock Spring on 2009 Chrysler 300?

  A:

  To maintain the SCCM, take all the assembly out so that history does not harm the Clock Spring pins. Make sure that the steering wheel and front tires are straight. When the SCCM is removed, then Clock Spring, and center it, clockwise and counterclockwise. And, lastly, install the SCCM and do not connect the battery until after testing.
• Q:

  How to Service an Air Bag Control Module on 2009 Chrysler 300?

  A:

  To service the Occupant Restraint Controller (ORC), disconnect the battery negative cable to deactivate the Supplemental Restraint System, wait for two minutes. Do not drop the ORC because it needs to be replaced if it is damaged. Remove the center floor console, disconnect wire harnesses and unscrew the ORC from the bracket.
• Q:

  How to Install an Airbag for Side Curtains on 2009 Chrysler 300?

  A:

  In order to fit the side curtain air bag, fit it along the roof side rail using push fasteners, install the inflator bolt at 11 Nm, fit the front tether to the A-pillar and screw it in at 5 Nm. Connect up the squib and replace the headliner without connecting to the battery until testing.