2010 Jeep Liberty Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2010 Jeep Liberty

• Q:

  How to Service an Air Bag Control Module on 2010 Jeep Liberty?

  A:

  To maintain the Occupant Restraint Controller (ORC), deactivate the Supplemental Restraint System (SRS), unplug the battery negative cable and wait two minutes. With the Occupant Classification System (OCS), component replacement should be done in stages and SRS verification tests should be conducted.
• Q:

  How to Install a New Clock Spring on 2010 Jeep Liberty?

  A:

  To install a new Clock Spring, turn off the SRS by disconnecting the negative battery cable and waiting 2 minutes. Make sure that the steering wheel is straight and locked. Transfer the multifunction switch harness Lock the Clock Spring with screws Install switches and shrouds Reconnect battery cable after removing the locking pin.
• Q:

  How Should You Safely Service an Air Bag Sensor in the Front Impact System on 2010 Jeep Liberty?

  A:

  Be sure to disable the SRS by disconnecting the negative battery cable before servicing the front impact sensor; allow two minutes. Handle the sensor with care, if dropped, replace the sensor. Access to the sensors by removing the air filter housing or raising the vehicle. Secure the sensor and tighten nut to 8Nm. Complete the SRS verification test procedure before reconnecting the battery.
• Q:

  How to Install an Airbag for Side Curtains on 2010 Jeep Liberty?

  A:

  In order to fit side curtain air bag, one has to disable the SRS by unplugging the negative battery cable, and wait two minutes. Wear personal protective equipment and no debris should get into the air bag. Install and fix the air bag with fasteners, tighten the nuts to 8 Nm, reconnect harness and reinstall headliner.