How to Replace a CV Boot on the Inner Tripod Joint on 2000 Chrysler Concorde?

To replace the inner tripod joint sealing boot, remove the driveshaft assemblies, discard the clamps. Slide off the old boot, take out the spider joint and check for wear. Install new boot and spider assembly, apply grease, and get stuff installed before you reinstall the driveshaft.

OEM 2000 Chrysler Concorde CV Boot

Axle Boot

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 CV Boots found

View related parts
2000 Chrysler Concorde Boot Kit Part Number: 4863722
Product Specifications
- Other Name: Boot - Half Shaft; CV Boot; Outer Boot; Boots; Boot Kit Half Shaft Outer
- Item Weight: 1.50 Pounds
- Item Dimensions: 6.4 x 6.4 x 5.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4863722
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Chrysler Concorde Submodels:
- Base, LX, LXi, Limited | 6 Cyl 2.7 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.5 L GAS
View related parts
2000 Chrysler Concorde Inner Boot Part Number: 4728261
Product Specifications
- Other Name: Boot - Halfshaft; CV Boot; Boot Kit Half Shaft Inner; Boot Package, Inner C.V.
- Item Weight: 1.60 Pounds
- Item Dimensions: 6.5 x 6.4 x 6.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4728261
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Chrysler Concorde Submodels:
- Base, LX, LXi, Limited | 6 Cyl 2.7 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.5 L GAS

2000 Chrysler Concorde CV Boot Parts and Q&A

Q: How to Replace a CV Boot on the Inner Tripod Joint on 2000 Chrysler Concorde?
A: To replace the inner tripod joint sealing boot, remove the driveshaft assemblies, discard the clamps. Slide off the old boot, take out the spider joint and check for wear. Install new boot and spider assembly, apply grease, and get stuff installed before you reinstall the driveshaft.