How to Locate, Remove, and Install a MAP Sensor on 2000 Chrysler Concorde?

The MAP sensor is attached on the driver side of the intake plenum manifold and it is removed by disconnection of negative battery cable and electrical connector. Installation: screw the sensor, tighten screws 4.5 Nm, reconnect the electrical connector, and reconnect the battery cable.

OEM 2000 Chrysler Concorde MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 MAP Sensors found

View related parts
2000 Chrysler Concorde Map Sensor Part Number: 4896131AC
$231.13 MSRP: $341.00
You Save: $109.87 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; Sensor Map; Pressure Sensor
- Replaced by: 68430060AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 3.8 x 2.6 x 1.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4896131AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Chrysler Concorde Submodels:
- LX | 6 Cyl 2.7 L GAS
View related parts
2000 Chrysler Concorde M.A.P. Sensor Part Number: 5293985AA
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; Pressure Sensor; MAP Sensor; Sensor Map
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.3 x 1.9 x 1.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5293985AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Chrysler Concorde Submodels:
- LXi | 6 Cyl 3.2 L GAS

2000 Chrysler Concorde MAP Sensor Parts and Q&A

Q: How to Locate, Remove, and Install a MAP Sensor on 2000 Chrysler Concorde?
A: The MAP sensor is attached on the driver side of the intake plenum manifold and it is removed by disconnection of negative battery cable and electrical connector. Installation: screw the sensor, tighten screws 4.5 Nm, reconnect the electrical connector, and reconnect the battery cable.