OEM 2003 Dodge Ram 2500 Van Washer Pump

2003 Dodge Ram 2500 Van Washer Pump Parts and Q&A

• Q: How to service the windshield washer pump on 2003 Dodge Ram 2500 Van?

  A: Start by taking out the washer reservoir from within the engine compartment. After removing the washer motor, remove the wire receptacle connectors from the engine harness wiring. In the next step, take off the washer supply hose from the outlet of the pump/motor to drain fluid into a clean dish which can be used another time. Reach inside the machine with a trim stick or other suitable tool and pry the barbed inlet nipple at the washer pump out from the rubber seal at the bottom of the reservoir carefully. Lift out and throw away the rubber grommet seal in the washer pump mounting hole in the reservoir. For installation, slide a new rubber grommet into the hole on the washer pump base in the reservoir tank. Set the barbed nipple on the washer pump into the rubber grommet in the reservoir, then press the pump firmly and evenly until it is all the way inside the seal. Rebox the washer hose to the pump's barbed outlet and connect the dash wire harness for the pump/motor to the receptacle on the motor unit. Install the washer reservoir in its original place and refill with the fluid you drained before.