OEM 2004 Jeep Liberty Fog Light Bulb

2004 Jeep Liberty Fog Light Bulb Parts and Q&A

• Q: How to Replace a Fog Light Bulb on 2004 Jeep Liberty?

  A: To remove the fog/driving lamp bulb, first turn the front of the car to the opposite side and remove the battery negative cable. Open the bulb by sliding your arm into the front wheel's hole and unsnapping the cover at the front wheelhouse splash shield. Reach in through the back of the fog lamp and twist the socket about 30 degrees towards the back of the car. Prevent contamination by not touching the bulb glass, since this can make the bulb wear out quickly. Slide both the socket and bulb directly out of the access hole and after that, take the bulb out of the socket. In order to avoid overheating and damage, the correct bulb must be installed when fitting a kitchen light. Match the base of the bulb with the receptacle in the socket and push it in slowly until it doesn't move. Cover the fog lamp opening with the socket, put the bulb through the hole and into the backside of the lamp housing and push in gently. After a 30-degree turn, replace the access cover and then link the battery's negative cable.