OEM 2006 Dodge Stratus Air Bag Control Module

2006 Dodge Stratus Air Bag Control Module Parts and Q&A

• Q: How to Safely Service the Air Bag Control Module on 2006 Dodge Stratus?

  A: You need to isolate the battery negative connector first, allow the system capsule to discharge for two minutes before getting to work on any Air Bag parts. If your car is manual, get rid of the shifter knob and boot, yet if it's automatic, just take off the shifter knob and snap off the bezel around the shift indicator next to it. After that, take out the four screws connecting the floor console and parking brake lever, along with the three mounting screws for the ORC. Disconnect all the wire harness connectors and pull out the ORC. For installation, first take out the battery, focus the ORC on the arrow at the front of the center tunnel and attach the wire harness connector. Connect the three mounting screws and tighten them to 9 N.m (80 in. lbs.), after that, put back the parking brake lever and the floor console, securing it with the four attaching screws. If your car has an automatic transmission, please replace the shift lever bezel and shifter knob and for a manual car, insert the shifter boot and knob. You should never plug in the battery negative cable remote terminal before diagnosing the air bag system or occupants might end up getting injured or killed without the air bag's protection.