JeepParts
My Garage
My Account
Cart
OEM 2007 Dodge Caravan CV Boot
Axle Boot- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 CV Boots found
Product Specifications- Other Name: Boot Kit - Half Shaft; CV Joint Boot Kit, Front Right Inner; CV Boot; Boot Kit Half Shaft Inner
- Position: Front Inner Passenger Side
- Item Weight: 1.10 Pounds
- Item Dimensions: 4.9 x 4.0 x 4.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5017781AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Product Specifications- Other Name: Boot - Half Shaft; CV Joint Boot Kit, Front Left Outer, Front Right Outer; CV Boot; Boot Kit Half Shaft Outer
- Position: Front Outer Passenger Side
- Item Weight: 1.10 Pounds
- Item Dimensions: 7.5 x 4.6 x 4.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5161251AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Product Specifications- Other Name: Boot Kit - Half Shaft; CV Joint Boot Kit, Front Left Inner, Front Right Inner; CV Boot; Inner Boot; Boots; Boot Package, Inner CV Right W/ABS; Boot Package, Inner CV Left; Boot Kit Half Shaft Inner
- Position: Front Inner Passenger Side
- Item Weight: 1.20 Pounds
- Item Dimensions: 5.6 x 3.9 x 4.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4797700
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2007 Dodge Caravan CV Boot Parts and Q&A
- Q: How to Service and Repair a CV Boot for Outer on 2007 Dodge Caravan?A: The first part of servicing the Constant Velocity Joint Boot is to remove the halfshaft assembly from the vehicle. Take the bigger boot clamp (4) out of the CV joint housing (3) and discard it and remove the smaller clamp (1) securing the outer CV boot to the interconnecting shaft (5) as well. Take off the sealing boot (2) so it lies over the shaft and wipe the grease away from the outside of the outer CV joint and shaft. Set the interconnecting shaft in a vise with protective caps, then carefully hit the front end of the CV joint housing with a soft-faced hammer (1) so the housing's tail releases from the circlip (3) inside. Gently push the CV joint off the end of the interconnecting shaft or use a gentle tap to remove it. You should always replace a circlip with a new one. Take off the circlip on the interconnecting shaft and then push the sealing boot further down. Next, inspect and clean the outside front and rear joints, plus the interconnecting joints; excessive wear shown on any part means you'll have to replace the halfshaft assembly, as the component parts in these assemblies are not serviceable.
