OEM 2007 Dodge Ram 2500 Vapor Canister

2007 Dodge Ram 2500 Vapor Canister Parts and Q&A

• Q: How to Install a Vapor Canister on 2007 Dodge Ram 2500?

  A: Before installing the EVAP canister, put the electrical connector on the ESIM switch so it is pointing toward the 3 O'clock position for safe use. With Type 1, install only a single vertical canister and the ESIM switch should be placed on it. Insert the two locating pins found in the back of the canister into the mounting bracket, assemble the mounting bracket bolt found under the ESIM switch, link the quick-connect vapor line to the canister, link the vapor line to the ESIM switch and connect the electrical wiring connector to the ESIM switch. In necessary circumstances, fit appropriate skid plates and double-check all lines and hoses for the EVAP canister purge solenoid, as finding leaks could set off a Diagnostic Trouble Code. For Type 2, do the following steps using the suitable canister and switch. Type 3, with two canisters placed one on top of the other, requires you to first install the secondary canister and push the locating pins into their places, then add the mounting bolt, fit the primary canister and repeat for both the vapor lines and electrical connections. For Type 4, install locating pins from the canisters into their mounting brackets, insert the mounting nuts, place the primary canister locating pins in position and install its mounting bracket nut, then add the vapor connections and wires. The next step is to slowly lower the vehicle after you know all connections are secure and not leaking.