OEM 2007 Dodge Sprinter 2500 Clock Spring

2007 Dodge Sprinter 2500 Clock Spring Parts and Q&A

• Q: How to Install a Clock Spring Assembly on 2007 Dodge Sprinter 2500?

  A: Begin by turning off the air bag system which is done by separating and isolating the battery negative terminal from the others. After two minutes, the system should be safe to use again. You should find that the molded plastic pin in a service replacement Clock Spring is pre-centered and should not move until you put the Clock Spring on the steering column. Turn and lock the steering wheel in the straight position before you start the engine. Slide the Clock Spring with the center detector down and over the top of the steering column and the bracket, until the wires lock together. Put the Clock Spring and multi-function switch onto the bracket, fix them with three screws and tighten them well. Disconnect the plastic locking pin or adhesive tape between the Clock Spring and shaft, set the steering wheel onto the shaft and reattach the battery negative lead. Turn the key to ON after finishing installation, rotate the steering wheel from the stop at the far right, to the stop at the far left and check for Diagnostic Trouble Codes (DTCs) using a scan tool because both the SCM and SAS are essential for the Clock Spring.