How is a Catalytic Converter Installed on 2008 Chrysler Crossfire?

To install the catalytic converter, inspect the exhaust manifold flange and replace if needed. Install and tighten bolts at the right exhaust pipe flange and all exhaust manifold flanges to 20 Nm. Connect the oxygen sensor wiring harness, then remove the exhaust system support and lower the vehicle.

OEM 2008 Chrysler Crossfire Catalytic Converter

Cat. Converter

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Catalytic Converters found

View related parts
2008 Chrysler Crossfire Catalytic Converter, Passenger Side Part Number: 5114404AA
Product Specifications
- Other Name: Converter - Catalytic; Catalytic Converter, Right; Converter Catalytic
- Position: Passenger Side
- Item Weight: 11.40 Pounds
- Item Dimensions: 40.6 x 9.9 x 10.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5114404AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Chrysler Crossfire Submodels:
- Base, Limited | 6 Cyl 3.2 L GAS
View related parts
2008 Chrysler Crossfire Catalytic Converter, Driver Side Part Number: 5114403AA
Product Specifications
- Other Name: Converter - Catalytic; Catalytic Converter, Left; Converter Catalytic
- Position: Driver Side
- Item Weight: 23.90 Pounds
- Item Dimensions: 61.2 x 17.5 x 14.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5114403AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Chrysler Crossfire Submodels:
- Base, Limited | 6 Cyl 3.2 L GAS

2008 Chrysler Crossfire Catalytic Converter Parts and Q&A

Q: How is a Catalytic Converter Installed on 2008 Chrysler Crossfire?
A: To install the catalytic converter, inspect the exhaust manifold flange and replace if needed. Install and tighten bolts at the right exhaust pipe flange and all exhaust manifold flanges to 20 Nm. Connect the oxygen sensor wiring harness, then remove the exhaust system support and lower the vehicle.