How to Service and Repair a Blend Door Actuator on 2008 Dodge Avenger?

First, secure the car by turning off the air bag system by removing the negative battery cable, then let the air bag system capacitor discharge for two minutes. Remove the glove box bin from your vehicle if you have a right-hand drive model. After that, disconnect the wire harness connector from the blend door actuator located on the left side of the HVAC air distribution housing. After that, unscrew the actuator from the air distribution housing and take it out.

OEM 2008 Dodge Avenger Blend Door Actuator

Air Blend Door Actuator

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

View related parts
2008 Dodge Avenger Actuator, Front Part Number: 68018109AA
$131.43 MSRP: $195.00
You Save: $63.57 (33%)
ADD TO CART
Product Specifications
- Other Name: Actuator - A/C And Heater; HVAC Inlet Door (Front, Rear), Defrost, Blend, Heater Blend; Actuator A/C And Heater Includes: Mounting Screws; Actuator A/C And Heater Includes: Screws; Actuator A/C And Heater
- Position: Front
- Item Weight: 0.60 Pounds
- Item Dimensions: 2.0 x 3.1 x 3.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68018109AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Dodge Avenger Submodels:
- Express, Heat, Lux, Mainstreet, R/T, SE, SXT, SXT Plus | 4 Cyl 2.4 L GAS, 6 Cyl 2.7 L FLEX, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L FLEX

2008 Dodge Avenger Blend Door Actuator Parts and Q&A

Q: How to Service and Repair a Blend Door Actuator on 2008 Dodge Avenger?
A: First, secure the car by turning off the air bag system by removing the negative battery cable, then let the air bag system capacitor discharge for two minutes. Remove the glove box bin from your vehicle if you have a right-hand drive model. After that, disconnect the wire harness connector from the blend door actuator located on the left side of the HVAC air distribution housing. After that, unscrew the actuator from the air distribution housing and take it out.