OEM 2008 Dodge Grand Caravan Seat Heater Switch

2008 Dodge Grand Caravan Seat Heater Switch Parts and Q&A

• Q: How to Install a Seat Heater Switch for the 2nd Row on 2008 Dodge Grand Caravan?

  A: You should place the 2nd row heated seat contact in the car, attach it using two screws and secure it firmly. After that, fix the wire harness routing clip to the car floor and plug in the seat contact electrical connector. Be sure the whole assembly is supported throughout the removal and installation process so you do not damage the 2nd row floor trim ring. Slide the trim ring to the vehicle, making certain the 4 holes match the weld studs and that the 2 wider parts at the front and the 2 narrower parts at the rear are placed on the center seat tub reinforcement. You should put the center two front and rear nuts on first, followed by the outer two nuts and finally install the retaining nut trim plugs, going from the center out to both edges of the panel. Put in the 2nd row seats and then tie the battery's negative lead to a ground.