Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
Fits the following 2009 Dodge Ram 2500 Submodels:
Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX, TRX4 | 5.9L L6, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 6.7L L6, 8 Cyl 5.7 L GAS
2009 Dodge Ram 2500 Brake Line Parts and Q&A
Q: How to Remove and Replace the Rear Brake Line on 2009 Dodge Ram 2500?
A: Start by setting up a prop rod on the brake pedal to make sure the master cylinder is not lowered which helps you avoid bleeding the whole system. Following that, raise and hold up the vehicle. Lift off the brake line (3) from the hose (1) near the frame and then remove the brake hose clip (2) at the top of the hose on the frame. At this point, disconnect the vent hose (2) as well as the two brake lines (3) from the hose base (1) which is by the axle. After that, remove the mounting bolt holding the hose to the axle and get the hose out.