Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2009 Dodge Ram 2500 Submodels:
Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX4 | 5.7L V8, 5.9L L6, 6 Cyl 6.7 L DIESEL, 6.7L L6, 8 Cyl 5.7 L GAS
| Page 1 of 2 |Next >
1-20 of 21 Results
2009 Dodge Ram 2500 Drive Shaft Parts and Q&A
Q: How to Ensure Proper Installation of a Drive Shaft on 2009 Dodge Ram 2500?
A: Place the slip yoke (1) onto the automatic transmission/transfer case output shaft (2) with the marks matching. For vehicles with a manual transmission, line up the transmission flange with the propeller shaft reference mark and add new bolts. Tighten these bolts to a torque of 115 Nm which equals 85 ft. lbs. For a vehicle with a two-piece propeller shaft, center bearing (1) with the marked lines on the bracket and use a torque wrench to tighten bolts (2) to 54 Nm (40 ft. lbs.). In the end, match the reference marks at the propeller shaft and pinion flange, insert the new companion flange (1) bolts and tighten them to 115 Nm (85 ft. lbs.). If you neglect to follow these instructions, you may notice your car's driveline is vibrating.