OEM 2009 Jeep Patriot Washer Reservoir

2009 Jeep Patriot Washer Reservoir Parts and Q&A

• Q: How to Install a Washer Reservoir on 2009 Jeep Patriot?

  A: Put the reservoir into the right corner of the engine compartment, aligning the post in the reservoir with the hole in the wheel house. Attach the mounting tab from the reservoir filler neck to the front right strut tower bracket with a screw, tightened to 9 Nm (79 in. lbs.). Connect the washer hoses from the front and the back to the reservoir hoses from the pump to guarantee proper operation of the washer systems. Reconnect the washer hoses from the front and back to those near the top of the right front strut tower and attach the washer pump/motor wire connector to the wire harness in the engine room. When removing the reservoir, if you moved the headlamp unit on a headlight leveling system, you should reinstall it. If the differential pressure sensor was disturbed during access to a diesel engine's forced air cooler, put it back. Set the coolant reserve container or coolant pressure container beside the washer reservoir and link them with right fasteners. Put fresh washer fluid in the reservoir, then join the negative cable back to its place on the battery.