OEM 2010 Jeep Wrangler Pitman Arm

2010 Jeep Wrangler Pitman Arm Parts and Q&A

• Q: How to Install and Secure a Pitman Arm on 2010 Jeep Wrangler?

  A: Set the pitman arm into place at the end of the steering gear shaft and put the washer and nut on. Tighten the nut to 251 Nm (185 ft. lbs.). After that, put the drag link ball stud on the pitman arm and tighten the nut to 105 Nm (77 ft. lbs.). Replace the track bar into the frame and sometimes this will involve prying the axle assembly to place the bar in the correct spot on the frame rail. Fit a nut and bolt to the track bar at the frame rail bracket, then tighten the bolt to 169 Nm (125 ft. lbs.). With the vehicle no longer supported, lower it and add the right level of power steering fluid. After that, have a look at how the shoe fits at the toe box.