OEM Chrysler Crossfire Air Bag Control Module

Chrysler Crossfire Air Bag Control Module Parts and Q&A

• Passenger Discriminating Sensor
  5102756AA
  Q: How to Service an Air Bag Control Module on Chrysler Crossfire?

  A:

  Before servicing the Air Bag Control Module, turn off the supplemental restraint system by disconnecting and isolating the battery negative cable and wait two minutes so the capacitor can discharge. Remove the center console and take off connector 2 from the occupant restraint controller. Proceed by breaking the free of the bolts 1 holding the occupant restraint controller to the transmission tunnel and removing the controller from the car. When installing, place the occupant restraint controller onto the mount at the top of the floor panel transmission tunnel, so the arrow on the housing faces toward the front of the car. Attach the controller to the frame by driving in the screws 1 to 11 Nm (95 in. lbs.) and matching the ground lead mount with the controller module's ground screw on the left-rear side. Connect the occupant restraint controller connector with part number 2 and replace your center console. Remember not to attach the negative battery cable yet, since you have to follow the Supplemental Restraint System verification test and ORC Programming after any such service.
• Control Module
  5099301AB
  Q: How to Safely and Correctly Install an Air Bag Control Module on Chrysler Crossfire?

  A:

  Before putting in the Air Bag Control Module, disabled the SR system by unhooking and isolating the battery's negative cable and it is important to wait for two minutes for the system capacitor to discharge. This serves to keep the air bag from automatically going off and causing injury. Carefully operate the occupant restraint controller to avoid causing drops or strikes, because falling it may ruin the impact sensor and lead to changing the module. Attach the occupant restraint controller at the mount welded to the top of the floor panel transmission tunnel, making sure the arrow inside faces toward the car's front. Install the occupant restraint controller to the mount using screws, paying attention to where the ground lead goes on the left rear screw and tighten everything to 11 Nm (97 in. lbs.). First, join the occupant restraint controller harness to its connector and then place the center console. You should not hook up the negative battery cable until the new ORC module has been programmed and the Supplemental Restraint System has been verified after servicing components of the system.