OEM Chrysler LHS Windshield Washer Fluid Reservoir

Chrysler LHS Windshield Washer Fluid Reservoir Parts and Q&A

• Reservoir Assembly
  5011823AB
  Q:

  How to Replace the Windshield Washer Fluid Reservoir on Chrysler LHS?

  A:

  The first step is to open the hood and take out the negative Battery Cable from the remote post to change the windshield washer reservoir. Hoist the car up and then prop the left edge of the front fascia with a 2x4 to give you space to remove it. Loosen the wire keepers for the reservoir pump and the float sensor and take off the washer hose and then block the liquid outlet to make sure there are no spills. Use one hand to get past the washing machine's back, then use the other hand to pull the filler tube from its connection to the rear. Break the seal with a tool and use the four bolts to unfasten the reservoir and take it out. Take out the fluid level sensor, pump and washer fluid and then add them to the replacement reservoir. To install the reservoir, fit it into its intended spot and fix it with the four securing bolts. Once again, attach the filler tube to the back of the reservoir, connect the washer hose to the washer pump and link up the wire connectors to the pump and the float sensor. Prop the left-side front fascia against your 2x4, then screw the fascia onto the car while you hold it in place by hand. unhook the vehicle from underneath and put back the negative battery cable to the terminal as it was originally.