To put in the first row seat belt and retractor, tighten the bolt to 39 Nm (29ft.lbs.) and then fit both the quarter panel and its screws and the quarter trim bolster. Connect the speaker after installing it; the left side goes onto the D-pillar trim cover and the right side is found behind the quarter trim panel, located after removing the D-pillar trim. Then, add the D-pillar trim cover, bolt in the second seat belt lower anchor, tighten it to 39 Nm (29 ft.lbs.) and finally secure the second seat belt upper turning loop anchor, also setting the torque to 39 Nm (29 ft.lbs.). Hang the upper liftgate trim and install the sill plate, then position and torque to 39 Nm (29 ft.lbs.) the first row seat belt upper turning loop anchor bolt, then do the same with the first row seat belt lower anchor bolt. Once you get to this section, set up the first and second row seats last.