To put the wiper motor linkage together, place the wiper module into the cowl plenum as a unit and connect the dash wire harness to the wiper motor pigtail wire connector. Loose the four screws (2) holding the wiper module in place, install them for a temporary fit, then quickly tighten the screws at the pivot brackets, first on the driver's side, then on the passenger's side, to 8 Nm (72 in. lbs.). After that, tighten the screws placed close to the motor bracket, first on the passenger side and then on the driver side, all to 8 Nm (72 in. lbs.). After fitting the cowl plenum cover/grille panel above the cowl plenum, attach the negative
Battery Cable, put the hood on, latch it securely and insert both
Wiper Arms onto the wiper pivots.