OEM Dodge Journey Vapor Canister

Dodge Journey Vapor Canister Parts and Q&A

• Vapor Canister
  4766519AD
  Q: How to Install a Vapor Canister for Emission Control on Dodge Journey?

  A:

  The electrical connector on the ESIM switch should be at the 3 O'clock position for correct operation during Evaporative Emission Control Canister installation. Double-check that the fresh air hose leading to the ESIM isn't being restricted, because such obstructions can block airflow and shut off the fuel upper. Make certain the O-ring and the EVAP canister opening are both clean before you try to install the ESIM. After that, fit the mounting brackets onto the EVAP canister assembly and put the assembly into your vehicle. Attach 4, the purge line, to the EVAP canister 1 and hook the fresh air line 2 and the electrical connector 3 to the ESIM. With 4 nuts 1, securewell 2 in place; lower the car; and then use your owner's manual to install the useful. After that, plug in the negative Battery Cable and tighten the nut until it has 5 Nm (45 in. lbs.) of force.
• Vapor Canister
  4766520AF
  Q: How to Service and Repair a Vapor Canister on Dodge Journey?

  A:

  Before fixing or servicing the Evaporative Emission Control Canister, disconnect and isolate the negative Battery Cable. Following this, take off the spare wheel, securing it somewhere safe and, using the jack, raise and support the vehicle as described in the manual. After taking out the 4 nuts and spare tire well, remove the 2 nuts that hold the EVAP canister mounting brackets to give you access to move the assembly. First, disconnect the purge line from the EVAP canister and afterwards remove both the fresh air hose and electrical connector from the ESIM. When that is done, disconnect the EVAP canister assembly from your car. Located on the back of the switch is a lock tab; push it in the direction of the switch while turning it counterclockwise once. Remove the ESIM from the EVAP canister at the end and remove the mounting brackets from the EVAP canister as well.