OEM Dodge Magnum Air Bag Sensor

Dodge Magnum Air Bag Sensor Parts and Q&A

• Impact Sensor, Front
  4671779AC
  Q: How to Safely Install an Air Bag Sensor for Front and Side Impact on Dodge Magnum?

  A:

  Line up the front impact sensor in the proper area and place it using two mounting screws, tightened to 7 Nm (62 in. lbs.); only after that, snap on the electrical connector. If you replace the left front impact sensor, you must install the air intake system as well. Correctly assemble the B-pillar mounted side impact sensor, screw it in place with two screws torqued to 7 Nm (62 in. lbs.), attach the corresponding electrical connector and then set the B-pillar trim panel into place. Install the C-pillar side impact sensor correctly, add two 7 Nm (62 in. lbs.) fastening screws, attach the electrical connector and set on the C-pillar trim panel. You should not attach the negative cable to the battery until you have finished the system test, to prevent any injury or death.
• Impact Sensor, Front
  4896173AA
  Q: How to Safely Service an Air Bag Sensor Mounted on the C-Pillar on Dodge Magnum?

  A:

  Before handling the C-pillar mounted side impact sensor, remove the battery negative cable and give it two full minutes to allow the reserve capacitor to discharge so the air bags won't be activated by accident. Following that, remove the panel from the C-pillar and take apart the electrical connection (3), before unscrewing the two screws (2). Position the C-pillar mounted impact sensor properly and fix it with two mounting screws (2), applying a torque of 7 N.m (62 in. lbs.) to each screw. Following this, attach the electrical connector (3) and put back the C-pillar trim panel in the correct place. You should never link the negative cable of the battery until the system check is completed, to prevent accidents.