This kit includes an electrical connection to the WCM/SKREEM, as well as a coax cable, two mounting clips and a combined control module and antenna. The control module is found besides the instrument panel cluster; its electrical connector is inserted into WCM/SKREEM on the right side of the steering column. Before you remove it, ensure the battery's negative cable is disconnected and isolated. After that, take out the steering column trim panel, the steering column shrouds and the IP cluster bezel. Afterwards, remove the four-cluster from the site along with its three connectors. After that, take out the two module mounting screws. Using long needle hose pliers, separate the retainer clip near the IP and then take apart the electrical connection to the WCM/SKREEM and then remove the whole remote module unit.